LYCOPRO PARAFFIN PROFESSIONAL WAX HEATER

1. Keep the heater on a flat surface.

2. Remove the lid, put paraffin wax in heater, then close it with the lid.

3. Keep the lid on when the heater is not in use.

4. Connect the heater to a power point. Turn the switch to setting 10 to heat up the paraffin. Setting 10 is about 70°C (158°F), which is too hot to apply to the skin.

5. Once the paraffin has melted, turn the switch to setting 4.5 to 5 and allow the paraffin to cool down and maintain the working temperature for the paraffin, which is about 50°C. The setting will depend if the lid is on or off. Setting 5 is about 50°C (122°F).

6. To increase temperature, move regulator dial clockwise.

7. To reduce temperature, move regulator dial anti-clockwise.

8. Always test the paraffin wax for a comfortable application temperature before use. How you test the paraffin temperature depends on how you are going to use the paraffin. If you are going to dip the hands or feet into the paraffin bath\, you need to test the paraffin by dipping your own fingers or full hand into the melted paraffin. You can also paint some paraffin onto your own hand to check if it feels comfortable before you apply it on the client’s skin. If paraffin feels too hot, you must allow the paraffin to cool down some more, then test the temperature again as explained above, to make sure the paraffin is comfortable to use on the client’s skin.

Please see Paraffin Application Tips for more information on the use and application of hygienic paraffin.

DO NOT immerse the heater in water.

DO NOT use the heater near water.

DO NOT allow water to splash onto the heater.

DO NOT clean the heater with water.

DO NOT overfill the heater. Fill up to around 2cm from the top of the insert.

DO NOT move the heater when it has hot melted wax inside.

Keep the heater away from children.